Suitable for a variety of low-slope commercial roofing applications, Elevate UltraPly TPO roofing membrane is a sustainable roofing solution for a wide range of building types.
UltraPly TPO membrane also offers design options with panels available in reflective white, tan or gray, which can help reduce a buildings cooling requirements. White and tan UltraPly TPO membranes meet the California Energy Efficiency Standards for Residential and Nonresidential Buildings (Title 24). These standards define cool roofs in California to have a minimum three-year aged reflectance of 0.55 and a minimum thermal emittance of 0.75 for low-sloped nonresidential buildings.
Contact Us
FEATURES AND BENEFITS
Ozone and Chemical resistant
Hot-air welded membrane
Available in 5', 8', 10' and 12' widths
Available in thicknesses of .045", .060" and .080"
Puncture resistant
Reduces roof's surface temperature
ULTRAPLY TPO OPTIONS
Elevates UltraPly TPO lightweight, flexible, scrim-reinforced membrane is engineered to provide dependable performance in most commercial roofing applications. Elevate offers a variety of installation options to meet the most demanding rooftop challenges for both renovation and new build applications.
Fully Adhered
In the Elevate UltraPly TPO Fully Adhered System, the TPO sheets are fully adhered directly to an acceptable substrate using contact adhesive. Adjoining sheets are overlapped at least 75 mm and heat-welded. Roof perimeters and penetrations are flashed in accordance with Elevate specifications.
Ballasted
In the Elevate UltraPly TPO Ballasted System, the TPO sheets are loosely laid over an acceptable substrate. Adjoining sheets are overlapped at least 75 mm and heat-welded. Roof perimeters and penetrations are flashed in accordance with Elevate specifications.
Mechanically Attached
The Elevate UltraPly TPO Mechanically Attached System uses sheets up to 3.05 m wide. The width of the sheet used and the fastening pattern differ to accommodate specific wind loadings. The sheets are attached in the overlap using approved plates and fasteners placed approx. 50 mm from the inside panel edge.